Ricoh C232SF User Guide - Page 105

Entering Characters Entering Characters This section describes how to enter characters using the control panel when configuring the machine's settings. There are three modes for entering characters, depending on the type of setting you are configuring: • Value input mode for entering numerical values. 2 • Fax number input mode for entering fax numbers. • Text input mode for entering names. Value Input Mode Value input mode becomes active when configuring settings such as paper size or copy zoom ratio. In this mode, use the keys as follows: • To enter a digit Press a number key. Press the number keys successively to enter a multi-digit number. • To increase or decrease the current value in units Press the {U}{T} keys. The unit of increments depends on the setting you are configuring. Note ❒ If a digit is entered more than three seconds after the last input, the entered digit replaces the current value. ❒ When the maximum number of digits has already been entered, the next input digit replaces the current value. ❒ If the current value is too large or too small for the current setting, it will not be accepted. In this case, pressing the {U} or {T} key changes the value to the minimum or maximum value for the current setting, respectively. 95