Sharp VL-WD450U VLWD450U|VLWD650U Operation Manual - Page 28
Installing the Lithium Memory, Battery
View all Sharp VL-WD450U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Preparation Preparation Installing the Lithium Memory Battery Installing the Lithium Battery The supplied lithium battery is used to store the memory of the date and time settings. 1 Press the LCD monitor OPEN release button (1) and open the LCD monitor (2). LCD monitor OPEN release button 5 Close the LCD monitor until it clicks into place. Removing the lithium battery Perform steps 1 and 2 above. Lift up the battery using a pointed object, and take it out. Note: • Replace the battery with a new CR2025 lithium battery when the time indicator of the camcorder starts to fall behind the correct time. 2 Open the lithium battery compartment door using the tip of a ballpoint pen or other pointed object. Notes on the Use of the Lithium battery REPLACE BATTERY WITH TOSHIBA, MATSUSHITA OR HITACHI MAXELL TYPE CR2025 ONLY. USE OF A DIFFERENT BATTERY MAY PRESENT A RISK OF FIRE OR EXPLOSION. X KEEP THIS BATTERY AWAY FROM CHILDREN. IF SWALLOWED, CONSULT A PHYSICIAN IMMEDIATELY FOR EMERGENCY TREATMENT. Z BATTERY MAY EXPLODE IF MISUSED OR INSTALLED WITH POLARITY REVERSED. DO NOT RECHARGE, DISASSEMBLE OR DISPOSE OF IN FIRE. 3 Insert the lithium battery into the compartment with the H side facing out. • Do not short-circuit, recharge, disassemble, or heat the lithium battery. • Should the lithium battery leak, wipe the battery compartment clean, and then insert a new battery. • The lithium battery will last about one year under normal usage. 4 Replace the compartment door, and close it firmly until it clicks into place. 13