Sony BRCH900 Product Manual (BRC-H900 Operating Manual) - Page 27

Overview BRBK-SF1 HD Optical Multiplex Card (not supplied) 1 BRBK-SF1 R L AUDIO IN 2 BRU A AUDIO IN L/R jacks (phono type) Input an audio signal (stereo), which is output from the AUDIO OUT jacks on the BRU-SF10 HD Optical Multiplex Unit via the Optical Fiber Cable. Note The audio input on this card accepts audio line signals only. When you input audio signals from a microphone, etc., it should be connected with a microphone amplifier so that audio signals with an appropriate audio level can be input. B Optical connector Performs the optical digital multiplex transmission of video, audio, external sync and control signals. A dustproof cap is attached at the factory. BRBK-HSD2 HD/SD-SDI Output Card (not supplied) 1 BRBK-HSD2 MONITOR 2 1 2 SDI OUT 3 OFF ON HD SD A SDI MONITOR OUT connector (BNC type) Outputs down-converted SD-SDI signals that conform to SMPTE 259M serial digital interface standards, and down-converted HD-SDI signals that conform to SMPTE 292 serial digital interface standards. When the menu display for the camera is turned ON, the menu display signal that overlaps the images is output from this connector. When the SDSDI output card is installed in the card slot of the BRU-SF10 HD Optical Multiplex Unit, you can also hide the menu display by using the DATA MIX switch on the BRU-SF10. For details, see "Images when menu display is ON" on page 27. B SDI connectors 1, 2 (BNC type) Outputs down-converted SD-SDI signals that conform to SMPTE 259M serial digital interface standards, and down-converted HD-SDI signals that conform to SMPTE 292 serial digital interface standards. When the menu display for the camera is turned ON, you can select whether to overlap the menu display with the image by using the C panel switch. For details, see "Images when menu display is ON" on page 27. C Panel switch Switch between SD-SDI signals and HD-SDI signals. When outputting HD-SDI signals, you can select whether to overlap the menu display with the image output from SDI connectors 1 and 2. For details, see "Images when menu display is ON" on page 27. Notes • SD-SDI and HD-SDI signals cannot be supplied simultaneously. • Set the panel switch before turning on the camera. • Do not push the switch forcibly with a screwdriver, etc. Images when menu display is ON When a BRBK-HSD2 is installed in the BRC-H900 card slot BRBK-HSD2 panel switch MONITOR connector SDI connectors 1, 2 Left position HD/ DATA MIX: ON a (HD-SDI output) Middle position HD/ DATA MIX: OFF a × (HD-SDI output) Right position SD a (SD-SDI output) a: Menu is superimposed on image ×: Menu is not superimposed on image 27 Location and Function of Parts GB