Sony BRCH900 Product Manual (BRC-H900 Operating Manual) - Page 39

Adjusting and Setting With Menus Setting range of TILT DOWN/TILT UP UP END (90°) 89° ±0° -29° END (-30°) Notes • Before storing the camera position in a preset memory, perform the PAN-TILT LIMIT setting. If the camera position is not within the range of the PAN-TILT LIMIT setting, you cannot store the camera position in the preset memory. • The PAN-TILT LIMIT setting is reset to the factory setting when you change IMG FLIP of the SYSTEM menu. • Before storing the camera position in a preset memory, install the camera suitably and fix the camera securely. If you change the installation of the camera after presetting, differences may arise on the preset. RAMP CURVE Select the panning and tilting speed acceleration or reduction mode when the preset panning and tilting operation is recalled. MODE1: Panning/tilting speed accelerates or reduces sharper than MODE2. MODE2: Panning/tilting speed accelerates or reduces with standard response. SYSTEM Menu IR RECEIVE IMG FLIP PAN REVERSE TILT REVERSE >DISPLAY INFO SYNC MASTER HPHASE HPHASE FINE STEADY SHOT COLOR BAR TALLY MODE VERSION ON OFF OFF OFF ON HD 03 0 OFF OFF LOW 1.00 IR RECEIVE (infrared signal reception) When it is set to OFF, the camera does not receive the signal from the supplied Remote Commander. Be sure to keep it ON when you use the supplied Remote Commander. Note You cannot set IR RECEIVE to OFF when you operate the menu using the supplied Remote Commander. To set it to OFF, use the RM-BR300 Remote Control Unit (not supplied) or the VISCA command. IMG FLIP (image flip) Set IMG FLIP to ON to rotate the camera image supplied from the RGB/COMPONENT, S VIDEO, T VIDEO, and SDI OUT connector and the connector on the optional Interface Card inserted into the card slot upside down and to reverse the direction of the camera movement by pan/tilt operation. Set PAN REVERSE to ON to reverse the horizontal movement of the camera image. Set TILT REVERSE to ON to reverse the vertical movement of the camera image. When you set IMG FLIP to ON, "Please restart system!" appears. Turn off the power of the camera, then turn it on again. Notes • Regardless of the IMG FLIP ON/OFF setting, images shot by the camera are accumulated for the vertical synchronization period and output from the RGB/ COMPONENT, S VIDEO, T VIDEO, and SDI OUT connector of the camera and the connector on the optional Interface Card inserted into the card slot. • When you set IMG FLIP to ON, turn off the camera, then turn it on again, PAN REVERSE and TILT REVERSE will be set to ON. When you set IMG FLIP to OFF, turn the power off, then on again, PAN REVERSE and TILT REVERSE will be set to OFF. 39 SYSTEM Menu GB