Sony BRCH900 Product Manual (BRC-H900 Operating Manual) - Page 72

Appendix List of Messages The following messages may appear on the screen. Take the necessary measures shown below. Indicators on the BRC-H900 camera Indicator Meaning/remedies STANDBY lamp flashes. The camera stopped moving due to an error in the pan/tilt mechanism. Reset the pan/tilt position or turn off the power of the camera, then turn it on again. The back tally lamp Turn off the power of the camera, then flashes. consult your Sony dealer. Messages for the BRC-H900 camera Message Meaning/remedies Please restart system! You are prompted to restart the power of the camera after you changed the setting of "IMG FLIP" in the SYSTEM menu. Use the POWER button on the supplied Remote Commander or the POWER button on the RM-BR300 Remote Control Unit to turn the power off, then on. The changed setting becomes effective. PRESET xx OK When you store the camera settings into (xx = preset position the memory (POSITION 1-16), the numbers 01 to 16) message will appear for two seconds. One Push WB...OK (NG) While the white balance is automatically adjusted, the message will appear. Wait for a while. When the adjustment is complete, it will disappear. FAN STOP! (The message will flash in the main menu.) Turn off the power of the camera, then consult your Sony dealer. CAUTION COOLING FAN STOPPED! Turn off the power of the camera, then consult your Sony dealer. PRESET (xx) OUT OF RANGE (xx = preset position numbers 01 to 16) This message appears when you preset the camera position when the pan/tilt position of the camera is out of range of the current PAN-TILT LIMIT setting. This camera position presetting will fail. Perform the presetting again after moving the camera within the range of the PAN-TILT LIMIT setting. Messages for video outputs from the BRU-SF10 HD Optical Multiplex Unit Message Communication error Please check connection Option card error Please check option card Meaning/remedies • The AC adaptor is not properly connected to the DC IN 12V connector on the BRC-H900, or the AC cord may be disconnected from the power outlet. Check that the BRC-H900 is turned on. • The CCFC-S200 Optical Fiber Cable connecting the BRC-H900 to the BRU-SF10 is connected improperly, or the optical fiber cable may be damaged. • Image frequency settings for the BRC-H900 and the BRU-SF10 may be different. For details on settings, see page 20 and 26. After checking the above conditions, restart the BRC-H900 and BRU-SF10. This message appears when an unsupported optional interface card is inserted in the card slot of the BRU-SF10. Remove the card after turning off the BRU-SF10. Appendix 72 GB List of Messages