Sony BRCH900 Product Manual (BRC-H900 Operating Manual) - Page 74

Symptom Cause Remedy The camera cannot be operated with the The connection using the VISCA RS-422 RM-BR300 Remote Control Unit. connectors is not correctly made. Check that the connection to the VISCA RS422 connectors is correctly made, and the RS422 cable is properly connected. The BOTTOM switch on the bottom of the camera is set to any other address than "0 (AUTO)." Identify the address of the camera, then select the same address by the CAMERA button of the Remote Control Unit. VISCA control setting is not correct. Select the proper setting (RS-232C or RS422) with the BOTTOM switch on the bottom of the camera (page 19) and the DIP switch on the Remote Control Unit (page 24). The communication baud rate setting of the camera and the RM-BR300 differ. Select the same communication baud rate (9,600 bps or 38,400 bps) with the BOTTOM switch on the bottom of the camera (page 19) and the DIP switch on the Remote Control Unit (page 24). The VISCA control is not available with The computer is not correctly connected to Make sure the connection between the a computer connected to the camera. the camera. computer and camera is made correctly. Check that the VISCA control setting (RS232C or RS-422) and the baud rate setting (9,600 bps or 38,400 bps) are properly made with the BOTTOM switch on the bottom of the camera (page 19) and the DIP switch on the Remote Control Unit (page 24). Try to connect the camera to the RM-BR300 Remote Control Unit to check that the camera works properly. The picture quality obtained from the Depending on your computer or video capture Consult your computer manufacturer or camera connected to a computer differs board, you may not be able to obtain the dealer for details. from that from the camera connected to a expected picture quality. video monitor. The camera cannot be operated at all. - Pull out the plug of the power cord from the AC outlet, then reinsert it into the AC outlet after a while. Appendix 74 GB Troubleshooting