ZyXEL NWA-3163 User Guide - Page 73

Chapter 3 Tutorials 2 Enable Redundancy. Then select Primary AP Controller and enter the IP address of the secondary controller AP (required). Click Apply. Note: Only NWAs in managed AP mode are visible to the controller AP. 3.6.5 Setting Your NWA in Managed AP Mode After setting the NWAs (A and E) to controller AP modes, you can now transform the NWAs (B, C and D) in the 2nd, 3rd and 4th floors of your company building to managed APs. It is very important to note that once an NWA is in managed AP mode, its web configurator cannot be viewed anymore. It cannot be accessed any other way other than through its controller AP's Web Configurator. The same rule applies to its TELNET, FTP and SMNP features. To put it simply, the managed NWA is not directly configurable. This is because its controller AP is continuously managing it. You can switch the NWA to standalone AP mode by pressing the reset button on the casing (NWA-3500 only). Previous configurations are lost. 1 To set your NWA in managed AP mode, open the MGNT screen in the Web Configurator of the NWA that you want to serve as a managed AP. Figure 48 Tutorial: Managed AP 2 Select Managed AP and enter the IP addresses of the NWA primary and secondary controller AP (recommended). Click Apply. Note: DCHP Server Option 43 enables your managed AP to send a request to be managed to controller APs that are within range, even if the controller AP belongs to another network. 3 You are logged out of the Web Configurator and the screen shows a message that the device is rebooting. You lose access to the Web Configurator. NWA-3160 Series User's Guide 73