ZyXEL P-870H-53A v2 User Guide - Page 58
Layer 2 Interface Configuration
View all ZyXEL P-870H-53A v2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Chapter 5 WAN Setup 5.4.1 Layer 2 Interface Configuration Click the Add button in the Layer 2 Interface screen to open the following screen. Use this screen to create a new DSL PTM interface. At the time of writing, you can configure only one DSL interface on the ZyXEL Device. Figure 29 DSL PTM Interface Configuration The following table describes the fields in this screen. Table 10 DSL PTM Interface Configuration LABEL DESCRIPTION Select Select MSC Mode to allow multiple WAN services over a single virtual Connection Mode circuit. Enable Quality Of Service Select VLAN MUX Mode to allow multiplexing of multiple protocols over a single virtual circuit. You need to assign a VLAN ID and priority level to traffic through each WAN connection. Select this option to activate QoS (Quality of Service) on this interface to group and prioritize traffic. Traffic is grouped according to the VLAN group. Back Apply/Save The QoS setting applies to all WAN connections over the same PVC. Click this button to return to the previous screen without saving any changes. Click this button to save your changes and go back to the previous screen. 58 P-870H/HW Series User's Guide