ZyXEL P-870H-53A v2 User Guide - Page 59
The Internet Connection Screen
View all ZyXEL P-870H-53A v2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Chapter 5 WAN Setup 5.5 The Internet Connection Screen Use this screen to change your ZyXEL Device's WAN settings. Click Network > WAN > Internet Connection. The summary table shows you the configured WAN connection(s) on the ZyXEL Device. To use NAT, firewall or IGMP proxy in the ZyXEL Device, you need to configure a WAN connection with PPPoE or IPoE. Note: When the DSL PTM interface is in VLAN MUX mode, you can configure up to eight connections over a DSL PTM interface on the ZyXEL Device. All WAN connections share one MAC address. When the DSL PTM interface is in MSC mode, you can have up to four WAN connections and only one bridge connection. Each WAN connection has its own MAC address. Figure 30 Internet Connection The following table describes the labels in this screen. Table 11 Internet Connection LABEL Interface DESCRIPTION This shows the name of the interface used by this connection. Description The default name ptm0_ or ppp0_ indicates the DSL port. The last number represents the index number of connections over the same PVC or the VLAN ID number assigned to traffic sent through this connection. This is the service name of this connection. Type Rate 0 and 1 are the default VPI and VCI numbers. The last number represents the index number of connections over the same PVC or the VLAN ID number assigned to traffic sent through this connection. This shows the method of encapsulation used by this connection. This shows the maximum data rate (in Kbps) allowed for traffic sent through this connection. This displays N/A when there is no limit on transmission rate. P-870H/HW Series User's Guide 59