Dell PowerEdge R910 Hardware Owner's Manual - Page 108
Removing a Hard-Drive Blank, Removing the Front Bezel
View all Dell PowerEdge R910 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
Removing a Hard-Drive Blank CAUTION: To maintain proper system cooling, all empty hard-drive bays must have drive blanks installed. 1 Turn off the system, including any attached peripherals, and disconnect the system from its electrical outlet. 2 If installed, remove the front bezel. See "Removing the Front Bezel" on page 87. 3 Press the release tab and slide the drive blank out until it is free of the drive bay. See Figure 3-11. Figure 3-11. Removing or Installing a Hard-Drive Blank 1 2 1 hard-drive blank 2 release tab Installing a Hard-Drive Blank 1 If installed, remove the front bezel. See "Removing the Front Bezel" on page 87. 2 Insert the drive blank into the drive bay until the blue release tab clicks into place. 3 If applicable, install the front bezel. See "Installing the Front Bezel" on page 87. 108 Installing System Components