Dell PowerEdge R910 Hardware Owner's Manual - Page 156
Installing a Power Supply, Supply Blank - rack chassis
View all Dell PowerEdge R910 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 156 highlights
Figure 3-32. Removing and Installing a Power Supply 1 2 3 1 power supply 3 cable retention bracket 2 locking tab Installing a Power Supply 1 Verify that power supplies are the same type and have the same maximum output power. NOTE: The maximum output power (shown in watts) is listed on the power supply label. 2 If applicable, remove the power supply blank. See "Removing the Power Supply Blank" on page 157. 3 Slide the new power supply into the chassis until the power supply is fully seated and the release latch snaps into place. See Figure 3-32. NOTE: If you unlatched the cable management arm in step of the previous procedure, relatch it. For information about the cable management arm, see the system's rack documentation. 4 Connect the power cable to the power supply and plug the cable into a power outlet. 156 Installing System Components