Dell PowerEdge R910 Hardware Owner's Manual - Page 89

Installing the System Identification Panel 1 Align the system identification panel with the slot on the chassis. 2 Slide the system identification panel into the chassis, until it locks into place. See Figure 3-3. 3 If applicable, install the front bezel. See "Installing the Front Bezel" on page 87. Opening and Closing the System WARNING: Whenever you need to lift the system, get others to assist you. To avoid injury, do not attempt to lift the system by yourself. CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. Opening the System 1 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet and peripherals. 2 Rotate the latch release lock counter clockwise to the unlocked position. See Figure 3-4. 3 Lift up the latch and slide the cover back toward the back of the system. 4 Grasp the cover on both sides and lift the cover away from the system. See Figure 3-4. Installing System Components 89