Dell PowerEdge R910 Hardware Owner's Manual - Page 140
Reconnect the system and peripherals to their power sources, and turn, Disconnect the SD module cable.
View all Dell PowerEdge R910 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 140 highlights
5 Disconnect the SD module cable. 6 Pull back slightly on the tabs at the edge of the card and gently lift the edge of the card off of the retention standoffs. 7 Install the I/O card. See "Installing the I/O Card" on page 135. 8 Close the system. See "Closing the System" on page 90. 9 Reconnect the system and peripherals to their power sources, and turn them on. Figure 3-26. Removing and Installing the Internal Dual SD Module 3 4 2 1 1 retention standoff posts (3) 3 SD module cable 2 retention standoff tabs (3) 4 dual SD module 140 Installing System Components
140
Installing System Components
5
Disconnect the SD module cable.
6
Pull back slightly on the tabs at the edge of the card and gently lift the
edge of the card off of the retention standoffs.
7
Install the I/O card. See "Installing the I/O Card" on page 135.
8
Close the system. See "Closing the System" on page 90.
9
Reconnect the system and peripherals to their power sources, and turn
them on.
Figure 3-26.
Removing and Installing the Internal Dual SD Module
1
retention standoff posts (3)
2
retention standoff tabs (3)
3
SD module cable
4
dual SD module
2
1
3
4