Dell PowerEdge R910 Hardware Owner's Manual - Page 88
System Identification Panel, Removing the System Identification Panel
View all Dell PowerEdge R910 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
System Identification Panel Removing the System Identification Panel 1 If applicable, remove the front bezel. See "Removing the Front Bezel" on page 87. 2 Pull the system identification panel out of its slot in the chassis, until it is in the lock position. See Figure 3-3. The system identification panel is located above the hard drive slot 8. 3 To release the left portion of the system identification panel, pull the panel to the right until it disengages from the slot in the chassis. 4 To release the right portion of the system identification panel, pull the panel to the left until it disengages from the slot in the chassis. Figure 3-3. Removing and Installing the System Identification Panel 1 1 system identification panel 88 Installing System Components