Dell PowerEdge R910 Hardware Owner's Manual - Page 185
Troubleshooting an Optical Drive
View all Dell PowerEdge R910 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 185 highlights
11 Close the system. See "Closing the System" on page 90. 12 Turn on the system and attached peripherals and check if the SD card is functioning. If the problem is not resolved, see "Getting Help" on page 203. Troubleshooting an Optical Drive CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1 If applicable, remove the bezel. See "Removing the Front Bezel" on page 87. 2 Try using a different CD or DVD. 3 Enter the System Setup program and ensure that the integrated SATA controller and the drive's SATA port are enabled. See "Using the System Setup Program and UEFI Boot Manager" on page 63. 4 Run the appropriate online diagnostic test. See "Using Online Diagnostics" on page 193. 5 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet. 6 Open the system. See "Opening the System" on page 89. 7 Ensure that the interface cable is securely connected to the optical drive and to the system board. See "Optical Drive" on page 113. 8 Ensure that a power cable is properly connected to the drive. 9 Close the system. See "Closing the System" on page 90. 10 Reconnect the system to the electrical outlet, and turn on the system and attached peripherals. If the problem is not resolved, see "Getting Help" on page 203. Troubleshooting Your System 185