Epson Expression 800 User Setup Information - Page 53

Installing the Transparency Unit, two mounting screws located

Get Epson Expression 800 PDF manuals and user guides View all Epson Expression 800 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 53 highlights

Before transporting the scanner, be sure to reinstall the shipping screw in the hole labeled CLAMP, and slide the transportation lock at the back of the scanner to the LOCK position. Installing the Transparency Unit Follow these steps to install the transparency unit on the scanner. 1. Make sure the scanner is turned off. Then unplug the power cable from the scanner. 2. Remove the document cover by grasping the back of the document cover as shown and easing the cover up. 3. Make sure the document table is clean and dust free. 4. Position the slots on the transparency unit's mounting bracket over the heads of the two mounting screws located at the back of the scanner. Slide the transparency unit forward slightly until the two holes in front of these slots are aligned with the screw holes at the back of the scanner. 46

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
46
Before transporting the scanner, be sure to reinstall the shipping screw in the hole
labeled
CLAMP
, and slide the transportation lock at the back of the scanner to the
LOCK
position.
Installing the Transparency Unit
Follow these steps to install the transparency unit on the scanner.
1.
Make sure the scanner is turned off. Then unplug the power cable from the
scanner.
2.
Remove the document cover
by grasping the back of the
document cover as shown and
easing the cover up.
3.
Make sure the document table
is clean and dust free.
4.
Position the slots on the
transparency unit’s mounting
bracket over the heads of the
two mounting screws located at
the back of the scanner. Slide
the transparency unit forward
slightly until the two holes in
front of these slots are aligned
with the screw holes at the back
of the scanner.