HP Designjet L26100 HP Designjet L26500 / L26100 printer series - Maintenance - Page 23
Remove the 95% ethanol and the cloth from the vicinity of the printer.
View all HP Designjet L26100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
6. Slightly dampen the used cloth with 95% ethanol to wipe the remaining dry ink deposits from the platen. NOTE: 95% ethanol is not provided in the User Maintenance Kit. CAUTION: Ethanol is highly flammable. Observe the manufacturer's safety precautions. CAUTION: Do not use commercial cleaners or abrasive cleaners. Do not wet the platen directly, because you will leave too much moisture behind, which could damage the substrate advance sensor. 7. Use the damp cloth to remove remaining dry ink deposits from the cutter ramp. 8. Use a dry cloth to clean the exposed part of the wheels. Ideally, you should clean the entire circumference of these wheels. Maintain hardware 9. Remove the 95% ethanol and the cloth from the vicinity of the printer. 10. Wait 3 or 4 minutes to let the ethanol evaporate, before turning on the printer and reloading the substrate. 11. With a 1 mm diameter pin ensure that the vacuum holes are not obstructed, especially the holes that are covered by the most-used substrate sizes. ENWW Clean the platen 17