HP Designjet L26100 HP Designjet L26500 / L26100 printer series - Maintenance - Page 41

9. Close and lock the printer window. 10. The front-panel display confirms that all of the printheads are correctly inserted. The printer starts checking and preparing the printheads. The default routine process, when all printheads are changed, takes up to 18 minutes. If the printer identifies a problem when preparing the printheads, the process takes longer, up to 30 minutes. For a single printhead insertion, the time varies between 10 and 20 minutes. After all printheads are checked and prepared, the printhead realignment procedure runs automatically if substrate is loaded. Replace the printhead cleaning kit The printhead cleaning kit contains the printhead cleaning cartridge, the ink funnel and the ink filter. When the front panel prompts you to replace the printhead cleaning kit, you should replace first the printhead cleaning cartridge, then the ink funnel, then the printhead cleaning container and ink filter. NOTE: The printhead cleaning container is not contained in the kit, but should be replaced at the same time. Therefore, make sure that you have a new printhead cleaning container ready, as well as a new printhead cleaning kit. TIP: If you want to remove and inspect the printhead cleaning cartridge at any time, you can start the following procedure. If you put the old printhead cleaning cartridge back into the printer after inspecting it, the procedure ends at that point. 1. On the printer's front panel, select the icon, then select Replace PH cleaning kit. 2. The printhead cleaning cartridge is located in a slot underneath the front panel, at the front of the printer. Open the door. Maintain hardware ENWW Replace the printhead cleaning kit 35