HP Designjet L26100 HP Designjet L26500 / L26100 printer series - Maintenance - Page 83

proxy configuration check box is selected, add the printer's IP address to the list of exceptions, for which the proxy server is not used. The printer is not printing Possible reasons why a file you have sent from your computer is not printing when expected, include the following: ● There may be a problem with the electrical power. If the printer is not performing and the front panel does not respond, check that the power switch at the rear is on, the residual current circuit breakers are up, the power cable is correctly connected, and the electrical socket is providing power. ● Unusual electromagnetic phenomena may exist, such as strong electromagnetic fields or severe electrical disturbances. Such occurrences can cause the printer to behave strangely, or even stop working. Turn off the printer by using the Power button on the front panel, wait until the electromagnetic environment has returned to normal, then turn the printer on again. If the problems persist, call your service representative. ● One of the following substrate scenarios may exist: ◦ The substrate name that appears on the front panel does not reflect the substrate that is loaded in the printer. ◦ There is not a sufficient amount of substrate on the loaded roll to print the entire job. Under these conditions, one print job might be printed, while another print job is held in the print queue. To resolve this issue, unload the roll from the printer and load a new roll, using the front panel to guide you through the process. The software program slows down or stalls while generating the print job Large quantities of data might be necessary to generate a high-quality large-format print job. This can cause your software program to slow down significantly or stall. Lowering the print resolution may help to avoid this scenario, however, lowering the print resolution reduces image quality. The printer seems slow Here are some possible explanations. ● If you request the highest possible print quality in the RIP, printing will be relatively slow compared with draft-quality printing. ● Ensure that the substrate loaded in the printer belongs to the substrate family that appears on the front panel. ● Are the printheads in good condition? Printing time tends to increase when a printhead needs cleaning. Check the printhead status on the front panel or through the Embedded Web Server. Clean or replace printheads if necessary. Troubleshoot other ENWW The printer is not printing 77