HP Designjet L26100 HP Designjet L26500 / L26100 printer series - Maintenance - Page 89

Table 10-2 Numeric error messages (continued) Error code Recommendation 32:01.1 This error occurs when there is a small amount of substrate printed, less than 79 in (200 cm) long. Check that there is no obstacle between the take-up reel optical sensors; that the substrate is attached to the take-up reel spindle; and that the take-up reel switch is in the correct position. If necessary, use the take-up reel arrow keys to wind the substrate; then press OK to resume printing. 32:01.2 This error occurs when there is a small amount of substrate printed, less than 70 in (178 cm) long. The take-up reel sensor detects that the loop shaper is (incorrectly) at the bottom of its path, even though the spindle motor has been rotating for more than 3 seconds. The most probable cause of this error is that you have forgotten to set the switch direction or tape the substrate to the spindle core, when the substrate reaches the floor and blocks the take-up reel's infrared sensors. Check that there is no obstacle between the take-up reel optical sensors; that the substrate is attached to the take-up reel spindle; and that the take-up reel switch is in the correct position. If necessary, use the take-up reel arrow keys to wind the substrate; then press OK to resume printing. 32:02 This error occurs during printer initialization, to warn you that the take-up reel has been disconnected while the printer was turned off. It also occurs if you try to enable the take-up reel, but it is not connected to the printer. Connect the take-up reel to the printer and press OK to continue. 41:03 Turn off the printer using the front panel and the power switch at the rear. Disconnect the power cords. Open the window and check for any visible obstacles restricting the movement of the drive roller. If there is a wrinkled mass of substrate in the substrate path, lift the substrate adjustment lever and clear the obstruction. Reconnect the power cords and turn the printer on again. If the problem persists, call your service representative. See When you need help on page 86. 42:03 Turn off the printer using the front panel and the power switch at the rear. Disconnect the power cords. Open the window and check for any visible obstacles restricting the movement of the printhead carriage. If there is a wrinkled mass of substrate blocking the carriage, lift the substrate adjustment lever and clear the obstruction. Reconnect the power cords and turn the printer on again. If the problem persists, call your service representative. See When you need help on page 86. 44:10 The waste management fan has failed. 44.1:01 The waste management system cable is disconnected; the cable from the printer cover to the interconnect could be disconnected too. 44.2:01 A switch has failed. Check the waste management system: the ink tube assembly should be connected and the ink filter door closed. 44.3:00 There is a short circuit in the waste management system cable, and perhaps also in the interconnect. 44.4:01 There is noise in the signal of the waste management system. Check that the connector is properly connected. 46:03 Turn off the printer using the front panel and the power switch at the rear. Disconnect the power cords. Reconnect the power cords and turn the printer on again. If the problem persists, call your service representative. See When you need help on page 86. Error messages ENWW 83