HP Designjet L26100 HP Designjet L26500 / L26100 printer series - Maintenance - Page 80
Reinsert printheads procedure, Image Quality Maintenance menu procedure
View all HP Designjet L26100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
TIP: Use the same substrate you intend to print on to align the printheads. WARNING! Colored substrates, glossy canvas, and transparent materials such as translucent bond, clear film, tracing paper, and vellum are not suitable for aligning the printheads. However, if you must perform printhead alignment with a material that is not supported, make sure you use a material with the same thickness as the material you are going to use for printing. Reinsert printheads procedure 1. If the printhead alignment process is running and the wrong substrate is loaded, press the Cancel button on the front panel. CAUTION: Do not print if the printhead alignment process has been canceled. 2. Load the substrate you want to use. Photo paper is recommended for the best results. WARNING! Colored substrates, glossy canvas, and transparent materials such as translucent bond, clear film, tracing paper, and vellum are not suitable for aligning the printheads. However, if you must perform printhead alignment with a material that is not supported, make sure you use a material with the same thickness as the material you are going to use for printing. 3. Remove and reinsert all of the printheads. See Replace a printhead on page 30. This starts the printhead alignment process. NOTE: Make sure the printer window is closed during printhead alignment. Troubleshoot ink 4. The process takes about 6 minutes. Wait until the front panel shows that the process is complete before using the printer. NOTE: A calibration image is printed during the printhead alignment process. The front panel shows if there were any errors in the process. Image Quality Maintenance menu procedure 1. Load the substrate you want to use. Photo paper is recommended for the best results. Plain; bond; and thin, coated substrates are acceptable, but provide marginal results. WARNING! Colored substrates, glossy canvas, and transparent materials such as translucent bond, clear film, tracing paper, and vellum are not suitable for aligning the printheads. However, if you must perform printhead alignment with a material that is not supported, make sure you use a material with the same thickness as the material you are going to use for printing. 2. Go to the front panel and select the icon, then select Image quality maintenance > Align printheads > Auto PH alignment. The printer verifies that a sufficient amount of substrate exists to perform printhead alignment. 74 Chapter 8 Troubleshoot ink-system issues ENWW