HP StorageWorks 1606 HP StorageWorks 8GB SAN Switch hardware reference guide ( - Page 39
Installing the outer rails HP 10000 Series rack
View all HP StorageWorks 1606 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
4. Assemble the outer rails. a. Attach the left outer rail and the right outer rail to the rear mounting brackets using two 1/4-20 hex nuts with captive star lock washers attached loosely, as shown in Figure 16. Do not tighten the nuts. Figure 16 Installing the outer rails (HP 10000 Series rack) . b. Depending on the rack you are using, complete one of the following tasks: • For an HP 10000 Series Rack, install two #10-32 x 1/2-inch Phillips panhead screws with captive star lock washers and two #10 adapter washers in the upper and lower holes on the right rail. Then, install two #10-32 x 1/2-inch Phillips panhead screws with captive star lock washers and two #10 adapter washers in the upper and lower holes on the left rail. (See Figure 17.) Figure 17 Assembling the outer rails (HP 10000 Series rack) . 8-Gb SAN Switch Hardware Reference Guide 39