Icom VE-PG3 Instruction Manual - Page 16

2 BRIDGE MODE APPLICATION 2. Operation in the Unicast mode (continued) 2. Connection Set the transceiver channel, volume level, TX output power, and other necessary settings, before connecting to the VE-PG3. 1 Connect the VE-PG3 and the transceiver, using the appropriate optional cable. • Verify that both the VE-PG3 and the transceiver are turned OFF when connecting the cable. VE-PG3 (Rear view) Icom's transceiver (IC-F5060/IC-F6060 series) (Rear view) To [TRX1] (Upper slots) PHONE LINE2 LINE1 A BC Be sure to insert the connectors top side up. To the external speaker jack (Front view) ABC 1234 Top A Bottom OPC-2275 To the microphone connector • The [TRX1] and [TRX2] ports (upper slots) accept the OPC-2275 connectors, however, follow the example to correctly connect the transceiver to ONLY the [TRX1] on the VE-PG3. 2 When all the connections are finished, turn ON the transceiver and VE-PG3's power. NOTE: • Verify that both the radio and the VE-PG3 are turned OFF when connecting or disconnecting the transceiver. • Keep the radio away from a PC, AC adaptor and other electronic equipment. The noise emitted from those equipment may interfere with the radio. • When operating the radio, do not transmit near the IP telephone. 2-6