Icom VE-PG3 Instruction Manual - Page 204
Status Detection, Default: RBT Stop
View all Icom VE-PG3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 204 highlights
6 CONVERTER MODE SETTING SCREEN 7. [V/RoIP] Menu (continued) MStatus Detection Configure the details for telephone line. [V/RoIP]-[LINE Settings] q Dial Tone Detect w Caller Connect e Caller Disconnect r Callee Disconnect ��� t Line Cut Select "Enable" to detect the dial tone signal. (Default: Enable) Select the detection type when the callee telephone's handset is picked up. (Default: RBT Stop) Select the detection type when the callee telephone is put on. (Default: BT) Select the detection type when the callee telephone is put on. (In the case of the call was initiated by the callee.). (Default: BT) Select "Enable" to detect when the telephone line is disconnected. (Default: Enable) 6-25
6
CONVERTER MODE SETTING SCREEN
6-25
7. [V/RoIP] Menu (continued)
M
Status Detection
Configure the details for telephone line.
q
Dial Tone Detect …………
Select “Enable” to detect the dial tone signal.
(Default: Enable)
w
Caller Connect ……………
Select the detection type when the callee telephone’s handset is picked up.
(Default: RBT Stop)
e
Caller Disconnect …………
Select the detection type when the callee telephone is put on.
(Default: BT)
r
Callee Disconnect ………
Select the detection type when the callee telephone is put on.
(In the case of the call was initiated by the callee.).
(Default: BT)
t
Line Cut ……………………
Select “Enable” to detect when the telephone line is disconnected.
(Default: Enable)
[V/RoIP]–[LINE Settings]