Icom VE-PG3 Instruction Manual - Page 57
When all the connections are finished, turn ON the transceiver and VE-PG3's power.
View all Icom VE-PG3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
3 CONVERTER MODE APPLICATION 7. Connecting to the Bridge mode's VE-PG3 (continued) 2. Connection Set the transceiver channel, volume level, TX output power, and other necessary settings, before connecting to the VE-PG3. 1 Connect the VE-PG3 and the transceiver, using the appropriate optional cable. • Verify that both the VE-PG3 and the transceiver are turned OFF when connecting the cable. VE-PG3 (Rear view) Icom's transceiver (IC-F5060/IC-F6060 series) (Rear view) To [TRX1] (Upper slots) PHONE LINE2 LINE1 A BC Be sure to insert the connectors top side up. To the external speaker jack (Front view) ABC 1234 Top A Bottom OPC-2275 To the microphone connector • The [TRX1] and [TRX2] ports (upper slots) accept the OPC-2275 connectors, however, follow the example to correctly connect the transceiver to ONLY the [TRX1] on the VE-PG3. 2 When all the connections are finished, turn ON the transceiver and VE-PG3's power. NOTE: • Full duplex communication is impossible. Communicate with each other by taking turns speaking. • Pause briefly before you speak, to confirm your party has finished speaking. • The communication route will be disconnected when the IP telephone's handset is put on the hook, or the VE-PG3 receives no audio for the preset time (default: 15 seconds). 3-33