Kyocera C270N Operation Guide - Page 111
Setting the Error Clear Time, Duplex Printing Error Detection Setting, >Auto Error, Clear ? Off
UPC - 632983011935
View all Kyocera C270N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
Using the Operator Panel 5 Press [OK] ([ENTER]). A blinking question mark (?) appears. >Auto Error Clear ? Off 6 Select On or Off using U or V. 7 Press [OK] ([ENTER]). 8 To exit the menu selection, press [MENU]. The display returns to Ready. Setting the Error Clear Time 1 Press [MENU]. 2 Press U or V repeatedly until Others > appears. Others > 3 Press Z. 4 Press U or V repeatedly until >Auto Error Clear > appears. >Auto Error > Clear On 5 Press Z and display >>Error Clear Timer. The default setting is 30 seconds. >>Error Clear Timer 030sec. 6 Press [OK] ([ENTER]). A blinking cursor (_) appears. >>Error Clear Timer 030sec. 7 Press U or V to increase or decrease the value at the blinking cursor and set the desired time. The time must be set between 000 and 495 seconds, in 5-second increments. If set to 000, printing will be continued immediately without any time interval. You can use Z and Y to move the cursor right and left. 8 Display the desired time and press [OK] ([ENTER]). 9 Press [MENU]. The display returns to Ready. Duplex Printing Error Detection Setting If the error detection setting for duplex printing has been turned On, and you attempt to print onto a paper size and paper type that cannot be used for duplex printing, the Duplex disabled Press GO error message will ADVANCED OPERATION GUIDE 2-85