Kyocera C270N Operation Guide - Page 60
Using the Operator Panel, ADVANCED OPERATION GUIDE, Printing a Network Interface Status
UPC - 632983011935
View all Kyocera C270N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
Using the Operator Panel 2 Enter the submenu by pressing Z. Each time you press U or V, the selection changes. >>DHCP Off >>BOOTP Off >>IP Address 000.000.000.000 >>Subnet Mask 000.000.000.000 >>Gateway 000.000.000.000 3 When >>IP Address is displayed, press [OK] ([ENTER]). A blinking cursor (_) appears at the last digit. >>IP Address 000.000.000.000 4 Press U or V to increase or decrease, respectively, the value at the blinking cursor. Use Z and Y to move the cursor right and left. 5 When the IP address is entered, press [OK] ([ENTER]). 6 Press U or V to move to Subnet Mask. Perform the same procedure to complete entering the subnet mask address. 7 Then, press U or V to move to Gateway. Perform the same procedure to complete entering the gateway address. 8 Press [MENU]. The display returns to Ready. You can print a network status page to confirm that the IP address, subnet mask address, and the gateway address have been properly set. To print a network status page, see Printing a Network Interface Status Page on page 2-35. 2-34 ADVANCED OPERATION GUIDE