Kyocera C270N Operation Guide - Page 57
>Baud Rate, >Data Bits, >Stop Bits, >Parity, >Protocol, DTRpos.&XON
UPC - 632983011935
View all Kyocera C270N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Using the Operator Panel Pressing U or V toggles through the serial parameters as follows. To change the serial parameter, press [OK] ([ENTER]). Use U or V to change the value or selection. >Baud Rate 9600 Range 1200, 2400, 4800, 9600 (Default), 19200, 38400, 57600, 115200 >Data Bits 8 7 or 8 (Default) >Stop Bits 1 1 (Default) or 2 >Parity None None (Default), Odd, Even, or Ignore >Protocol DTR(pos.)&XON DTR(pos.)& Xon (Default), DTR(positive), DTR(negative), XON/XOFF, or ETX/ACK For example, to change baud rate from 9600 to 115200, display the baud rate menu following the above procedure. When the display shows baud rate, 9600 (bps), press [OK] ([ENTER]). A blinking question mark (?) appears. >Baud Rate ? 9600 7 Press U or V to scroll through values. When 115200 is displayed, press [OK] ([ENTER]). Press [MENU] to exit the menu selection. NOTE: Some computers may not be able to handle a baud rate of 115200 bps. If you set the baud rate to 115200 and encounter communication problems, select a lower baud rate. ADVANCED OPERATION GUIDE 2-31