Lexmark E238 Service Manual - Page 102

4511-xxx Sub error codes First 6 bytes sub error code data (xx can be any value) 84 00 22 x1 x2 00 84 01 22 x1 x2 00 84 x1 30 x2 x3 x4 84 1x 2D x2 x3 x4 84 xx 00 x1 x2 x3 Explanation Possible error message Indicates the media reached the image 200 point before EP leading edge state machine was ready. (x1=leading edge of media state, x2=trailing edge of media state) Media reached the image point before EP 200 trailing edge state printer was ready. (x1=EP leading edge state, x2=EP trailing edge state.) Motor head transport motor error. (x1=motore type, x2=error code, x3=TimWatchingHallCount, x4=TimeWatchingHallPeriod.) Misidentified no gap jam. Engine detected no gap at the manual feeder sensor, attempted to open the gap by stopping the feed rolls, trailing edge was seen at the input sensor, manual feeder sensor is no longer covered. (x1+x2=page ahead's expected length, x3+x4=Page ahead's measured length) This code indicates that the input sensor 200 is still actuated from the first sheet, and the second sheet is ready to arrive at the sensor. (x1=FsyncFall flag for Page Ahead, x2=media source, x3=last measured gap at input sensor).) • Check the printer input sensor and flag for correct operation. The flag should operate freely. • Check for debris in the area of the input sensor. • Check the area of the transfer roll and input to the fuser for anything that might cause the paper to remain over the input sensor. 2-70 Service Manual