Lexmark T430 Service Manual - Page 110

4048-1xx Page Count Reset the page count when an engine card is replaced. To reset the page count: 1. Select Page Count from the PRINTER SETUP menu. Page Count =1234567* 2. The leftmost number blinks. Use Menu to increase or decrease the number and press Select to move to the next digit to the right. Continue until the correct number displays. To skip a number without changing it, press Select. When Select is pressed after the last digit, the number is saved. Perm Page Count This menu option lets you view the permanent page count. The permanent page count cannot be changed by the operator panel. Select Perm Page Count and the value is displayed. Configuration ID The configuration ID is used to communicate characteristics of certain areas of the printer that cannot be determined by hardware sensors. The configuration ID was originally set when the printer is manufactured and is located on the printer label. Edge to Edge When Edge to Edge is set to On, text and graphics are printed with all margins set to the physical edges of the page. This features does not work in PPDS emulation. Par S Strobe Adj This setting adjusts the factory setting for the amount of time strobe is sampled to determine that valid data is available on the parallel port. Incrementing this value by one means the strobe is sampled 50 nanoseconds longer. The range of values are between -4 and +6, in increments of one. A value of zero indicates no change is made from the factory setting. 3-16 Service Manual