Lexmark T430 Service Manual - Page 57
Paper jam messages continued
View all Lexmark T430 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
4048-1xx Paper jam messages (continued) Message 238 Paper Jam Check Duplex 239 Paper Jam Remove Tray 1 Pull Down Lever At Printer 242 Paper Jam Check Tray 2 243 Paper Jam Check Tray 3 250 Paper Jam Check MP Feeder 1565 Emul Error Load Emul Option Explanation A piece of media is most likely jammed in the duplex area. Remove tray 1 and pull down the lever to access the jam area. If the paper is not in the duplex area, then check the rear of the printer by opening the rear door. A paper jam has occurred in the duplex unit. Indicates a load problem with the exit motor (also serves as a duplex motor). High load could be from using non-specified (too heavy) media in duplex, paper path obstructions, high frictional forces in the redrive unit (rear cover), or a worn motor. can be Front or Rear. Tray 2 pass thru sensor is covered during warm-up. Try opening Tray 2. If the tray is difficult to remove, then you may have to remove the tray above or below the tray to remove the jammed pages. Media picked from tray 3 made it through the tray 2 pass thru sensor, but failed to make the input sensor in time. Media in the multipurpose feeder was picked (two attempts, if necessary), but did not make it to the input sensor. The emulation version on the card does not function with the printer code. The correct version must be downloaded. Diagnostic information 2-23