Lexmark T430 Service Manual - Page 62

4048-1xx Sub error codes (continued) First 6 bytes sub error code data (xx can be any value) 84 xx 20 x1 x2 84 xx 22 x1 x2 00 84 xx 23 x1 x2 x3 84 xx 26 84 xx 2F x1 x2 x3 Explanation Possible error message The imaged page is not the expected 200 page. (x1=media size, x2=media source) Check the pass thru sensor to make sure it is operating properly. If no problem is found, it may still be necessary to try a new pass thru sensor. This code indicates that the media 200 activated the input sensor before the printer EP was ready. (x1=leading edge of media state, x2=trailing edge of media state) The transfer servo never started. 200 (x1=media size, x2=leading edge of media state, x3=trailing edge state). Possible causes: • Slow or missing main motor positional feedback. Paper too fast to input sensor. • Gap too small on interpage servo. This code indicates that media has 200 activated the input sensor; however, the printhead fell out of lock condition or expected a stable lock too soon. The media may have also reached the input sensor early. Laser servo never started due to potential 200 conflict with the transfer servo. (x1=bit 0: transfer servo started, bit 1: transport started; x2+x3=transfer servo count value.) Possible cause is slow or missing transport motor positional feedback. 2-28 Service Manual