Lexmark T430 Service Manual - Page 56
Paper jam messages
View all Lexmark T430 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
4048-1xx Paper jam messages Repeating jams or jam messages can be caused by any of the following: • Faulty pick solenoids or worn cams of the solenoids. • Faulty flags or springs. • Worn backup rollers at the reference guide. • Improperly adjusted reference guide. • Debris in the paper path. • Paper not of the specified length. Paper jam messages Message 200 Paper Jam Remove Cartridge 201 Paper Jam Remove Cartridge 202 Paper Jam Open Rear Door 231 Paper Jam Remove Tray1 Pull Down Lever At Printer Rear 235 Paper Jam Remove Tray1 Pull Down Lever At Printer Front 237 Paper Jam Check Duplex Explanation The input sensor under print cartridge is covered too long or is covered during POR or when Go is pressed after clearing a different jam or problem. The exit sensor could also be covered. Remove the print cartridge and open the rear door to remove the media. Paper is jammed between the printer input and exit sensor. Remove the print cartridge to clear the paper path. The exit sensor is either covered during POR or covered too long. Open the rear door to access the jam area. A piece of media did not arrive at the duplex input sensor, but did leave the printer exit sensor. A piece of media is over the duplex sensor after a sheet has been picked from the duplex. A piece of media did not reach the printer input sensor after leaving the duplex unit. 2-22 Service Manual