Lexmark T430 Service Manual - Page 64
E 00, 00 0F 00
View all Lexmark T430 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
4048-1xx Sub error codes (continued) First 6 bytes sub error code data (xx can be any value) 89 00 01 89 xx 03 89 xx 04 x1 89 xx 0D 89 00 0E 00 00 00 89 00 0F 00 00 00 Explanation Possible error message The exit sensor at the fuser is activated by 202 a piece of media indicating there is a piece of media in the machine during POST. Check for media in the exit of the fuser assembly or redrive assembly. Feed a sheet of paper, and if the same error occurs after clearing the fuser or the same error occurs when no media is present, check the exit sensor assembly. Turn the printer off, enter the diagnostic tests menu, and select the base sensor test. Select output sensor and check the sensor for correct operation. The fuser exit sensor did not detect the 202 trailing edge of the media going through the fuser assembly. • This failure can be caused by a broken fuser exit sensor flag. • This may also be caused by erratic operation of exit sensor flag or exit sensor or a defective piece of media. The fuser exit sensor never actuated from 202 the sheet going through the fuser before the next page begins feeding. (x1=media size) The fuser exit sensor bounced. Check the 202 exit sensor for correct operation. Check the sensor cable to J16 on the controller card. Also, the controller card may be failing. Exit sensor never changed state from 202 sheet ahead of page heading toward exit sensor when feeding out media detected during warm-up. Trailing edge never cleared exit sensor 202 when feeding out media that was detected during warm-up. 2-30 Service Manual