Ricoh Aficio MP 7500 S/P General Settings Guide - Page 66

System Settings ❖ Ethernet Speed Set the access speed for networks. Select a speed that matches your network environment. [Auto Select] should usually be selected. • Auto Select • 10Mbps Full Duplex 2 • 10Mbps Half Duplex • 100Mbps Full Duplex • 100Mbps Half Duplex ❖ LAN Type When you have installed the optional IEEE 802.11b interface unit, select interface, IEEE 802.11b (wireless LAN) or Ethernet. • Ethernet • IEEE 802.11b Appears when the IEEE 802.11b interface unit is installed. If Ethernet and IEEE 802.11b (wireless LAN) are both connected to the machine, the selected interface takes precedence. ❖ Ping Command Check the network connection with ping command using given IPv4 address. If you fail to connect to the network, check the following, and then retry the ping command. • Check TCP/IP of the printer is active. • Check that the machine with assigned IPv4 address is connected to the network. • There is a possibility that same IPv4 address is used for the specified equipment. ❖ Permit SNMPv3 Communication Set the encrypted communication of SNMPv3. • Encryption Only • Encryption / Clear Text If you set to [Encryption Only], you need to set password for the machine. ❖ Permit SSL / TLS Communication Set the encrypted communication of SSL/TLS. • Ciphertext Only • Ciphertext Priority • Ciphertext / Clear Text If you set to [Ciphertext Only], you need to install the server authentification for the machine. ❖ Host Name Specify the host name. Enter the host name using up to 63 alphanumerical characters. 58