Yamaha SY85 Owner's Manual (feature Reference) (image) - Page 107

2: SEND, MIX, WET:DRY [VOICE] → [EFFECT EDIT] → [MENU] → 2:Send, Mix, Wet:Dry → [ENTER/YES] The balance between the direct sound of the voice and the effect sound is a delicate thing. Even slight changes can make a big different to the final sound. The parameters provided in this screen provide precise balance control. EF`Level``Send```EF2`Mix```Out1`Wet:Dry 127 50`:`50` F1 F2 F3 F4 F5 F6 F7 F8 CS1 CS2 CS3 CS4 CS5 CS6 CS7 CS8 Send (Send level) Range: 0 ... 127 Controls: [CS3], [-1] [+1], Dial This parameter adjusts the amount of direct voice signal that is sent to the effect processors, determining the strength of the final effect sound. A setting of "0" results in no effect, leaving only the "dry" sound of the voice. The maximum setting of "127" produces the maximum amount of effect. EF2 Mix (Effect 2 mix level) Range: 0 ... 100 Controls: [CS5], [-1] [+1], Dial This parameter can only be used with the "serial" effect mode is selected. If any other mode is selected ("off" or "para"), "---" appears on the display in place of the value. If a controller is assigned to the EF2 Mix parameter (page 110), an inverse "c" will appear to the right of the parameter. Out1 Wet Range: 0 ... 100 Controls: [CS7], [-1] [+1], Dial This parameter and the "Out1 Dry" parameter, below, work together to balance the effect ("wet") and direct ("dry") signals delivered via the OUTPUT 1 jacks. Higher "Out1 Wet" values produce more effect sound in relation to the direct, dry sound of the voice. Although the "Wet" and "Dry" parameters can be set independently, adjusting one will cause the other to change so that their total is always 100(%). If a controller is assigned to the "out1 Wet" parameter (page 110), an inverse "c" will appear to the right of the parameter. 106 VOICE EDIT MODE / EFFECT EDIT