Brother International HL-2600CN Service Manual - Page 162

46 NVRAM INITIAL This mode can initialize (data clear) all the data of NVRAM on MCTL PWB 2, and also can execute NVRAM CLEAR to clear C3 error when occurred. WARNING NVRAM INITIAL is not used under normal circumstances; Bear in mind that execution of this mode is beset with loss of all the data in NVRAM. Therefore, all the data in NVRAM should be stored prior to executing NVRAM INITIAL. Description of Procedures 1) Press the Reprint button after selecting "NVRAM INITIAL". (a) (b) a) 2) Select YES if NVRAM should be executed. If not select NO. Press the Reprint button so that the RAM b) INITIAL will be executed. (All the data will be cleared.) (b) (c) 4) Following modes shall be executed to set the RAM data. c) 43 MARGIN ADJUST 44 LIFE PERIOD SET 45 NVRAM TUNE UP 47 TOTAL PAGE SET 48 EACH IMAGE SET 49 NEXT LIFE SET * When setting NVRAM TUNE UP, LP TUNE UP to be set at "-3". LCD Message 39 FACTORY MODE NVRAM INITAL 46 NVRAM INITIAL YES / NO 39 FACTORY MODE DP CHECK V-37