Brother International HL-2600CN Service Manual - Page 383

iv) Is there anything under the printer, or is there something stuck to the printer base? 5) After checking these items, initialize the printer again (opening/closing the top cover automatically initializes the OPC belt cartridge), and measure the gap on the OPC belt cartridge again. If the gap is in the range of 5 ± 2 mm, the printer is installed correctly. (Refer to the figure for Step 3).) 6) If the gap is NOT in the range of 5 ± 2 mm, follow the steps below; i) When the gap is more than 7 mm; (the OPC belt has moved to the right.) Place something 1 cm thick such as a book under the right hand side of the printer as shown in the figure on the right. Initialize the printer again and then measure the gap on the OPC belt cartridge. If the gap is in the range of 5 ± 2 mm, the printer is installed correctly. Printer base Book Metal frame A-37