Brother International HL-2600CN Service Manual - Page 343
Insufficient Gloss, Back Stain
![]() |
View all Brother International HL-2600CN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 343 highlights
I-21 Insufficient Gloss Phenomenon Gloss of the print is not sufficient as shown in print sample (21) of Fig.8-2. Main Causes 1) The fuser cleaner is stained. 2) The fusing roller 2 is deteriorated. Countermeasures 1) Replace the fuser cleaner with a new one. (See Section 3.1 of Chapter III.) 2) Replace the fusing unit with a new one. (See Section 2.2 of Chapter VI.) Note: When replacing the fusing unit, wait approximately for 30 minutes after the new unit is installed to allow the fusing oil to circulate in the new fusing unit. I-22 Back Stain Phenomenon Back side of the print paper is stained as shown in print sample (22) of Fig.8-2. Main Causes Fusing unit: 1) The cleaning pad of the fuser cleaner is stained. 2) Silicone oil in the oil bottle is short. 3) The fusing roller 2 and back-up roller are dirty. Countermeasures 1) Replace the fuser cleaner with a new one. (See Section 3.1 of Chapter III.) 2) Clean the fusing roller 2 and back-up roller. 3) Replace the fusing unit with a new one. (See Section 2.2 of Chapter VI.)
![](/manual_guide/products/brother-international-hl2600cn-service-manual-a175c80/343.png)