Brother International HL-2600CN Service Manual - Page 289
Operator Call, Toner Empty X, No Toner X, Cover Open, Jam X, No Paper T1/2, Waste Toner, Oil Empty - paper jam a1
![]() |
View all Brother International HL-2600CN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 289 highlights
2. OPERATOR CALL 2.1 Video Controller Mode The Ready LED is lit and an applicable message appears on the liquid crystal display (LCD) in the following cases; 1) Consumables require to be replenished. 2) Waste toner pack is full of waste toner. 3) Paper jam. 4) Periodic maintenance. 5) Maintenance work incomplete. The above cases are not regarded as a breakdown, and should be treated in accordance with Table 8-1; Table 8-1 Display Message Remarks TONER EMPTY X X = C, M, Y, K Replace the X toner cartridge. NO TONER X X = C, M, Y, K Install the X toner cartridge. COVER OPEN Close the Front Cover. COVER OPEN Close the Top Cover. COVER OPEN Close the Rear Access Cover. COVER OPEN Close the Lower Feeder Unit Cover. COVER OPEN Close the Duplex Unit Cover. JAM X X = A1, A2, B, C, D, E1 ,E2 Refer to the diagram, and check the location. Remove the jammed paper. NO PAPER T1/2 Load paper into Tray 1/2. WASTE TONER Replace the waste toner pack. OIL EMPTY Replace the oil bottle. CHANGE FCR Replace the cleaning roller. NO OPC BELT Install the OPC belt. NO FC ROLLER Install the cleaning roller.
![](/manual_guide/products/brother-international-hl2600cn-service-manual-a175c80/289.png)