Brother International HL-2600CN Service Manual - Page 283

23) Remove the E rings (1 pc.) to remove the (gear A) from the fusing unit. 24) Remove the E rings (1 pc.) to remove the (gear B) from the fusing unit. 25) Remove the E rings (1 pc.) to remove the (gear C) from the fusing unit. 26) Remove the E rings (1 pc.) to remove the (gear D) from the fusing unit. 27) Remove the E ring (1 pc.) to remove the (shaft). E ring (gear C) E ring (gear B) E ring (shaft) (gear D) E ring (gear A) Fig.7-103 E ring PRECAUTION Do not touch the surface of the heater lamp with your hands, the small traces of oil you leave on the lamp will affect the life of the lamp. The wattage of the heater lamp is different between the fuser roller and the back-up roller. The wattage is marked on the insulator of the lamp electrode. Fuser roller: 560W Back-up roller : 420W Note: When installing the new fusing unit into the printer, you have to wait approximately for 30 minutes after the unit is installed to allow the fusing oil to circulate in the unit. VII-72