Brother International MFC-7160C Users Manual - English - Page 101

86 CHAPTER TEN Remote Commands Follow the commands below to access features remotely. When you call the MFC and enter your Remote Access Code (1 5 9 ), the system will signal you with two short beeps to enter a remote control command. Remote Control Commands Details Operation 95 Changing Fax Forwarding /Paging setting 1 OFF 2 Fax Forwarding 3 Paging 4 FAX FWD No. If you hear one long beep, the change is accepted. If you hear three short beeps, you cannot change it because the conditions have not been met (Example: registering paging number). You can register your fax forwarding number by using 4. FAX FWD NO (see page 87). Once you have registered the number, the MFC will change automatically to FAXFWD:ON mode. Then retrieve a Memory Status List by entering 961 (see page 87) to make sure that the Fax Forwarding number you registered is correct in the List. 6 Fax Storage ON You can turn FAX STORAGE ON or OFF. 7 Fax Storage OFF 96 Retrieve FAX 1 Memory Status List 2 Retrieve all faxes Enter the number of a remote fax machine to receive the Memory Status List or stored fax message(s). (See page 86.) 3 Erase fax from the memory If you hear one long beep, you can erase fax message(s) from the memory. 97 Check the receiving status 1 FAX You can check whether your MFC has received any fax message(s). If yes, you will hear one long beep. If no, you will hear three short beeps. 98 Change Answer Mode 1 TAD 2 FAX/TEL If you hear one long beep, you can change the Answer Mode. If you hear three short beeps, you cannot change it. 3 FAX 90 Exit After a long beep, you can exit remote control.