D-Link DGS-3426 User Manual - Page 188
Time Range, Access Profile Table, CPU Interface Filtering,
View all D-Link DGS-3426 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 188 highlights
xStack DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch Section 9 ACL (Access Control List) Time Range Access Profile Table CPU Interface Filtering Time Range The Time Range window is used in conjunction with the Access Profile feature to determine a starting point and an ending point, based on days of the week, when an Access Profile configuration will be enabled on the Switch. Once configured here, the time range settings are to be applied to an access profile rule using the Access Profile table. The user may enter up to 64 time range entries on the Switch. NOTE: The Time Range commands are based on the time settings of the Switch. Make sure to configure the time for the Switch appropriately for these commands using commands listed in the following chapter, Time and SNTP Commands. To open the Time Range window, click ACL > Time Range, which will display the following window for the user to configure. Figure 9- 1. Time Range Settings window The user may adjust the following parameters to configure a time range on the Switch: Parameter Description Range Name Hours Enter a name of no more than 32 alphanumeric characters that will be used to identify this time range on the Switch. This range name will be used in the Access Profile table to identify the access profile and associated rule to be enabled during this time range. This parameter is used to set the time in the day that this time range is to be enabled using the following parameters: • Start Time - Use this parameter to identify the starting time of the time range, in hours, minutes and seconds, based on the 24-hour time system. • End Time - Use this parameter to identify the ending time of the time range, in hours, minutes and seconds, based on the 24-hour time system. 174