Dell PowerEdge C6220 II Hardware Owners Manual - Page 155

Installing the Heat Sink CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1 Using a clean lint-free cloth, remove the thermal grease from the heat sink. 2 Apply new thermal grease evenly to the center of the top of the new processor. CAUTION: Using excess thermal grease can cause grease to contact the processor shield, which can cause contamination of the processor socket. 3 Place the heat sink on the processor. See Figure 3-13. 4 Using a Phillips screwdriver, tighten the four heat-sink retention screws. 5 Replace the system-board assembly. See "Installing a System-Board Assembly" on page 150. Processors This system board supports dual Intel E5-2600 or E5-2600 v2 processor series, which is up to 135W, 3.5GHz and 12 cores, based on Intel Patsburg PCH chipset. Removing a Processor CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1 Remove the system-board assembly. See "Removing a System-Board Assembly" on page 149. Installing System Components | 155