Dell PowerEdge C6220 II Hardware Owners Manual - Page 241

CAUTION: If removed, you must replace the power distribution board 2 and the power distribution board-connector before replacing the power distribution board 1. 1 If removed, first place the power distribution board 2 in the system. See Figure 3-73. Otherwise skip to step 5. NOTE: To install the power distribution board 2 below the power distribution board 1, angle the board during installation. 2 Replace the screws securing the power distribution board 2 to the system. See Figure 3-73. 3 Replace the power distribution board-connector. See Figure 3-72. 4 Connect all the cables to the power distribution board 2. See Figure 375. You must route these cables properly through the tabs on the chassis to prevent them from being pinched or crimped. 5 Replace the power distribution board 1 to the system. See Figure 3-71. 6 Replace the screws securing the power distribution board 1 to the system. See Figure 3-71. 7 Connect all the cables to the power distribution board 1. See Figure 374. You must route these cables properly through the tabs on the chassis to prevent them from being pinched or crimped. 8 Replace the power supply. See "Installing a Power Supply" on page 147. 9 Close the system. See "Closing the System" on page 231. 10 Reconnect the system to its electrical outlet and turn on the system, including any attached peripherals. Installing System Components | 241