Dell PowerEdge C6220 II Hardware Owners Manual - Page 194
Installing the Riser card for 1U Node, Removing the Riser card for 2U Node
View all Dell PowerEdge C6220 II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 194 highlights
Installing the Riser card for 1U Node CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1 Place the riser card into the expansion-card bracket. See Figure 3-39. 2 Replace the two screws securing the riser card to the expansion-card bracket. See Figure 3-39. 3 Install the expansion card. See "Installing the Expansion Card for 1U Node" on page 164. 4 Replace the system-board assembly. See "Installing a System-Board Assembly" on page 150. Removing the Riser card for 2U Node CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. NOTE: Both 1.5U riser card and 2U riser card can be supported in the 2U-node system. 1 Remove the system-board assembly. See "Removing a System-Board Assembly" on page 149. 2 Remove the expansion card. See "Removing the Expansion Card for 2U Node" on page 165. 3 Turn the expansion-card bracket upward as shown in Figure 3-40 and Figure 3-41. 4 Remove the two screws securing the 1.5U riser card to the expansioncard bracket. See Figure 3-40. 194 | Installing System Components