Dell PowerEdge C6220 II Hardware Owners Manual - Page 170
Insert the card-edge connector firmly into the expansion-card
View all Dell PowerEdge C6220 II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 170 highlights
Assembly" on page 149. 4 Remove the four screws that secure the expansion-card assembly. 5 Lift the expansion-card assembly away from the system-board assembly. 6 Remove the screw securing the filler bracket. 7 Grasp the filler bracket by its edges, and carefully remove it from the expansion-card connector. NOTE: Keep this bracket in case you need to remove the expansion card. Filler brackets must be installed over empty expansion-cards slots to maintain FCC certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system. 8 Holding the expansion card by its edges, position the card so that the card-edge connector aligns with the expansion-card connector on the riser card. 9 Insert the card-edge connector firmly into the expansion-card connector until the card is fully seated. 10 Install the expansion slot lock cover by securing the four screws. 11 Place the expansion-card assembly into the system-board assembly. 12 Replace the screws that secure the expansion-card assembly. 13 Replace the system-board assembly. See "Installing a System-Board Assembly" on page 150. 170 | Installing System Components