Dell PowerEdge C6220 II Hardware Owners Manual - Page 71

 BMC LAN Port Configuration: Dedicated-NIC  DHCP Enabled: Disabled or Enabled (Enabled if DHCP server support)  IP Address: 192.168.001.003  Subnet Mask: 255.255.255.000  Gateway Address: 000.000.000.000 To do this, see "Set BMC LAN Configuration" on page 100. Note that the host and client need to have the same network section. To enable SOL feature in the mode of Shared-NIC, perform the following steps: 1 Connect the LAN cable to NIC connector 1. For location of NIC connector 1 on the back panel, see Figure 1-14 item 5. 2 Enter the server BIOS setup screen. 3 Enter Set BMC LAN Configuration screen and verify the following settings:  Remote Access: enabled  Serial port number: COM2  Serial Port Mode: 115200 8, n, 1  Flow Control: None  Redirection After BIOS POST: Always  Terminal Type: ANSI To do this, see "Remote Access Configuration" on page 101. Note that the last four options need to sync with the host and client. 4 Enter LAN Configuration screen and verify the following settings:  BMC LAN Port Configuration: Shared-NIC  DHCP Enabled: Disabled or Enabled (Enabled if DHCP server support)  IP Address: 192.168.001.003  Subnet Mask: 255.255.255.000  Gateway Address: 000.000.000.000 To do this, see "Set BMC LAN Configuration" on page 100. Note that the host and client need to have the same network section. Using the System Setup Program | 71