Dell PowerEdge C6220 II Hardware Owners Manual - Page 260
Direct Backplanes
View all Dell PowerEdge C6220 II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 260 highlights
Item Cable Hard-drive backplane cable Hard-drive backplane cable From (Bottom Middle Plane) Mini-SAS connector for system board 1 (J1) Mini-SAS connector for system board 3 (J3) To (Expander Card) Mini-SAS connector ( 4~7) for system board 1 Mini-SAS connector (12~15) for system board 3 Direct Backplanes Following is the replacement procedure of SATA2 and SAS direct backplane for 3.5-inch hard drive systems. Replacement procedure for 2.5-inch of SATA2 and SAS direct backplane is similar to the direct backplane for 3.5inch hard drive systems. Removing the Direct Backplane CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1 It is recommended to turn off the system, including any attached peripherals, and disconnect the system from its electrical outlet. 2 Remove all the hard drives. See "Removing a Hard-Drive Carrier" on page 142. 3 Open the system. See "Opening the System" on page 230. CAUTION: To prevent damage to the drives and backplane, you must remove the hard drives from the system before removing the backplane. CAUTION: You must note the number of each hard drive and temporarily label them before removal so that you can replace them in the same locations. 260 | Installing System Components