Dell PowerEdge C6220 II Hardware Owners Manual - Page 164

Installing the Expansion Card for 1U Node CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. CAUTION: Expansion cards can only be installed in the slots on the expansioncard riser. Do not attempt to install expansion cards directly into the riser connector on the system board. 1 Unpack the expansion card and prepare it for installation. For instructions, see the documentation accompanying the card. 2 Remove the system-board assembly. See "Removing a System-Board Assembly" on page 149. 3 Remove the four screws that secure the expansion-card assembly. 4 Lift the expansion-card assembly away from the system-board assembly. 5 Remove the screw securing the filler bracket. 6 Grasp the filler bracket by its edges, and carefully remove it from the riser card. NOTE: Keep this bracket in case you need to remove the expansion card. Filler brackets must be installed over empty expansion-cards slots to maintain FCC certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system. 7 Holding the card by its edges, position the card so that the card-edge connector aligns with the expansion-card connector on the riser card. 8 Insert the card-edge connector firmly into the expansion-card connector until the card is fully seated. 9 Replace the screw securing the expansion card. 10 Place the expansion-card assembly into the system-board assembly. 11 Replace the four screws that secure the expansion-card assembly. 12 Replace the system-board assembly. See "Installing a System-Board Assembly" on page 150. 164 | Installing System Components